MIDAS-T-NP1 热解器选件安装在标准Midas 气体检测器下方。空气ample 通过热解器被吸入传感器盒。热解器将空气中存在的目标气体转化为ample 通过热解转化为氟化氢(HF)。然后可以通过传感器测量HF，并将浓度显示为目标气体的等效读数（以ppm 为单位）。
为在使用热解器时保持传感器精度，建议每6 个月进行一次气体校准，并且安装点的环境温度不要超过10-40°C (50°F) 高于此温度的操作可能需要更频繁的通气测试或校准以确认工作规范。由于使用热解器模块时工作温度较高，因此Honeywell Analytics 强烈建议在所有热解器应用中使用通风Midas 顶盖（部件号MIDAS-A-104）。
High Temperature Pyrolyzer Module for Perfluoro Compounds (PFC) Gas Detection. (order separate transmitter unit)
Higher Temperature Pyrolyzer MIDAS transmitters provide detection of NF3 , Hexafluorobutadiene (C4F6 ), Methyl Fluoride (CH3F) and Octofluorocyclopentene (C5F8 ). Unit includes a snap on pyrolyzer module that operates with any Universal MIDAS Extractive Transmitter (order separately). Units are powered via direct connection to transmitter unit. Consult Honeywell Analytics for additional gases detectable with this option. Pyrolyzer includes Pyrolyzer Quick Start Guide and installation screws. Order the PFC cartridge (MIDAS-S-XCF or MIDAS-E-XCF) separately. Order the ventilated top cover (MIDAS-A-103 or MIDAS-A-103G) separately.
Midas Gas Detector Transmitter & Sensor Combination
Extractive Midas transmitters (universal) operate with sensor cartridges, for use as a local gas detector. Sensor Cartridges must be ordered separately. Units are powered by 24VDC or via Power over Ethernet PoE. Transmitters provides 0-22mA analog and Modbus/TCP Ethernet as standard outputs. Integral relays for A1, A2 and fault are included, and may be wired normally open or normally closed, latched or unlatched. Transmitters include Manual, Quick Start Guide, and (1) PG16 gland fitting for power in and relays out, 1/4" O.D.x 1/8" I.D. Sample Inlet tubing (10') [3m], 1/4" O.D x 3/16" I.D. Exhaust tubing (10') [3m], and a sample line tubing duct adapter (1283K1090). Order a sensor cartridge separately for each transmitter.
Order the following parts for a complete Midas System:
Midas or Midas transmitter and cartridge kit
Sensor cell (if combo kit not purchased)
Sample and exhaust tubing
End of line filters
